| Series | Model No. | Output Watts | Input Voltage | Input range | Polarity Protection | | 120 | STC-1201100RD | 1100W continuous | ±120V DC
(Optional 110V AC) | ±85V ~ ±144V DC
(Optional 90V ~ 130V AC) | Fuse protected |
ENVIRONMENTAL CONDITIONS:● Cooling: Forced Air-cooling, 40x40x28 mm Fan x 2 (With Two Ball Bearing) ● Fan brand: DELTA, NMB, SUNON. Specifications are equivalent ● Operating Temperature: 0°C ~ +50°C (Full Load) ● Output Power: 100% @ 50°C, 70% @ 60°C ● Operating Humidity: 20%~85% RH. (Non condensing) (95% Optional) ● Storage Temperature: -20°C ~ +80°C ● Storage Humidity: 10%~90% RH. (Non condensing) ● Operating Altitude: 10M Below Sea level and 3000M Above Sea level
DC INPUT CHARACTERISTICS:● Input connector type: 30A/300V terminal part # HD-341-02PH ● Input Current: 9A/15A (1100W) @ Full Load High Line & Low Line ● Inrush Current: Less than 50A Cold start @25°C ambient
DC OUTPUT CHARACTERISTICS:| Output Voltage | Regulation | Output Current | Ripple & Noise | | Load | Line | Cross | 1100W | | Min | Max | | +5V | ±5% | ±1% | ±5% | 1A | 35A | 50mV | | +12V | 1A | 92A | 120mV | | +3.3V | 0.5A | 22A | 50mV | | -12V | ±8% | 0A | 1.0A | 120mV | | -5V (optional) | ±5% | 0A | 0.3A | 50mV | | +5VSB | ±5% | 0A | 3.5A | 50mV | | Maximum continuous combined load on +3.3 V & +5V DC output shall not exceed | 175 | Watts | | Maximum continuous combined load on +3.3 V & +5V & 12V DC output shall not exceed | 1070 | | Maximum continuous total DC output power shall not exceed | 1100 |
OVERALL PERFORMANCE:● Efficiency: 82% typical @120V DC Full Load ● Hold up time: The output voltage stays regulated for at least 16ms with 100% load after loss of DC input ● Rise time: The output voltage rise from 10% to 90% with full load shall be in 20ms maximum ● Power Good Signal: TTL Compatible signal, on delay 100~500ms, off delay 1ms min ● Short Circuit Protection (SCP): All output equipped with SCP (shutdown and latch off) ● Over Power Protection (OPP): Peak power protected to 130%±10% of continuous rated power (shutdown and latch off) ● Over Voltage Protection (OVP): +3.3V@3.6V~4.3V, +5V@5.5V~6.5V, +12V@13.2V~15.6V
RELIABILITY:● MTBF (Mean Time Between Failure): 100 000 hours @max. Load, 120V DC & 25°C ambient ● Safety Standards: Meet IEC 60950-1, EN 60950-1 ● EMI Compatibility (EMC) Standard: EN 55032:2015/AC:2016, CISPR 32:2015, EN 61000-3-2:2014, EN 61000-3-3:2013, EN 55024:2010 +A1:2015
ISOLATION:● Isolation Mechanism: INPUT and OUTPUT are isolated by transformers and optical couplers ● Dielectric Withstand INPUT to OUTPUT: 2000V DC for 60 seconds ● Dielectric Withstand INPUT to frame GROUND: 2000V DC for 60 seconds ● Leakage Current: <0.005μA @120V DC
LED Indicator:
● Power module 1: Green LED when Power On
● Power module 2: Green LED when Power On
Alarm function:
● In the rear panel with power failure alarm signal to indicate when power failure wire
Alarm reset switch:
● To reset by switch
Output Connector specific:● ATX 24 pin x 1: Molex 29-01-2240 or equivalent ● HDD, DVD 4 pin x 2: Molex 8981-04P or equivalent ● FDD 4 pin x 2: AMP 171822-4 or equivalent ● Serial ATA x 8: Molex 675820000 or equivalent ● CPU EPS 8 pin x 2: Molex 39-01-2080 or equivalent ● PCIE (6+2) pin x 4: (Max 8 sets) ● 12VHPWR (12V-2x6) x 1: 600W Optional ATX 3.1 compliant
Standard Output Cable Length:
● 500 mm / 19.68 Inches
PCB specific:
● 6 layer
● Copper: 3 Oz each layer
● Thickness: 1.6mm
● Material: FR4
● PCB material origin: Taiwan
Power Chassis Dimension:
● 375(L) x 150(W) x 86(H) mm / 14.76(L) x 5.9(W) x 3.39(H) Inches
Rackmount Chassis Solution:
● 4U IPC Chassis 510mm GHI419ATX
Screw hole:
● Front panel with 4 screw holes
● Rear panel bracket with screw holes
Net Weight:
● 8.2 kg / 18.08 lbs
Gross Weight:
● 10 kg / 22.05 lbs
Packing Detail / 2pcs:
● 56 x 32 x 42 cm / 2.65 Cuft
● N.W. 16.4 kg / 36.16 lbs
● G.W. 17.5 kg / 38.58 lbs
NOTE:
● Power Supply is not able to be used in stand alone application
● Use Power Supply in Power Chassis Assembly only
SPECIFICATIONS:
|
